#160354 - FLUX MLH-2200 BRUSHLESS MOTOR (50mm WIRE)
The Flux MLH-2200 is the centerpiece of our latest 1/8th scale
brushless-powered vehicles. If you're looking for jaw-dropping and
awe-inspiring power for your 1/8th scale off-road vehicles, this is
where you can stop looking! The Flux MLH-2200 will give you more
than enough power for anything you're looking for: giant air
stunts, multiple back flips, colossal top speeds, and
wheel-spinning sideways action!
Featuring the sleekest heatsink design of any HPI 1/8th scale
brushless motor case, the Flux MLH-2200 has 11 heat-radiating ribs
circling the black-anodized case. These fins help dissipate the
heat that the motor will generate as it spins up to thousands of
times per second to give you the awesome stunt action you want to
get out of your RC car or truck.
With the ability to handle twin 3S LiPo batteries (that's more than
22 volts of LiPo power!), the Flux MLH-2200 can deal with anything
you can ask of it! 6.5mm bullet connectors on 12-gauge motor
connector wires transmit maximum power from the speed controller
for instant wheelie or dirt-throwing action.
With a 5mm motor shaft, you can fit any of the available optional
pinions for your Vorza, Savage Flux HP or Savage XL Flux.
The Flux MLH-2200 has a 4-pole rotor for high torque, fast
acceleration response, and stable power output.
The machined aluminum housing, alloy steel output shaft, and
high-precision bearings ensure high durability and smoothness.
Please note: The Flux MLH-2200 must be used with an ESC that can
handle the immense power it requires, the #160353 Flux ELH-6S Waterproof ESC is
the perfect match!
This version of the Flux MLH-2200 Motor featues 50mm Wires
that are the perfect for the Savage X Flux V2!
Technical Specifications:
KV (No Load): 2200KV
LiPo: 2-6S
Resistance (Ω): 0.0058
No Load Current: 5A
Poles: 4
Connector: 6.5mm Bullet
Dimensions (mm): Φ=42 / L=74
Shaft (mm): Φ=5 / L=18.5
Weight: 418g
Application: 1/8th Buggy/Monster Truck
NOTE: Before driving in wet conditions, make
sure that other electronics fitted to the vehicle are safe to use
(marked as water-resistant or waterproof), or that they are fully
enclosed and protected from water and moisture (such as in a sealed
receiver/battery case). Fans mounted on speed controllers are not
water resistant - we recommend to disconnect the fan from the
ESC before driving in wet conditions and allow it to dry fully
before reconnecting the fan power. Lubricate exposed metal
drivetrain parts such as bearings, outdrives and diff shafts
before driving in wet conditions. Motors are not intended for
submerged use and may be damaged if used when under water. After
driving in wet conditions, make sure to rinse off dirt and any
corrosive liquids like saltwater with plain water and
re-lubricate metal drivetrain parts.